Clean the area to be repaired using pre-treatment wipes. Wipe dry.

Cut the tip off the Colour Tube according to the desired size, usually a smaller hole is best.

Apply a small amount of paint either onto the squeegee, brush or directly to the chip.

Use the squeegee to level the paint into the chip if required

Allow the paint to dry for 2-3 minutes. In areas of poor ventilation or high humidity, assistance with a fan or hairdryer can help.

As the paint dries it levels very well, the colour can also change a lot. Please do not judge the colour before it dries.

Once dry apply a liberal amount of finishing solution to the wiping cloth, keeping the cloth flat rub over the repair until the excess paint has been removed.

Wipe dry and clean the surface with the microfibre towel.

If you wish to build in layers it is best to give it as much time as you can between layers, 10 minutes being the minimum an hour being optimal.

Avoid harsh polishing or buffing for a period of 7 days

You can reseal the Colour Tube using the supplied reseal stickers or use piece of tape if desired. It is best to clean the end of the tube with the precleaning wipes before resealing.